System Configuration - Omron CK3E Series Connection Manual

2-2

System Configuration

The configuration devices for reproducing the connection procedures in this document are shown be-
low.
Power PMAC IDE
Sysmac Studio
Manufacturer
OMRON
OMRON
OMRON
OMRON
OMRON
OMRON
OMRON
DT
Precautions for Correct Use
Auto-update the Sysmac Studio to the version specified in this section or later. Using a version
that is not specified in this section may cause differences in the procedures in Section 3 and
later. In that case, refer to the Sysmac Studio Version 1 Operation Manual (Cat. No. W504) to
perform equivalent procedures.
Additional Information
This documents provides an example of connecting an NJ501-1500 and a CK3M-CPU1£1.
You can use similar procedures to connect CK3E-££££ and other NJ/NX-series CPU Unit.
CK3E/CK3M-series EtherNet/IP Connection Guide (O903)
CK3M-CPU1 1
EtherNet/IP
Ethernet
W4S1-05B
Name
NJ/NX-series CPU Unit (With built-in EtherNet/IP
port)
Power Supply Unit
Industrial Switching Hub
Sysmac Studio
Programmable Multi-Axis Controller
Industrial Switching Hub
Ethernet Cable (Industrial Ethernet connector cable)
Power PMAC IDE
2 Target Device and System Configuration
NJ501-1500
EtherNet/IP
Model
NJ501-1500
NJ-PA3001
W4S1-05B
SYSMAC-SE2£££
CK3M-CPU1£1
W4S1-05B
XS5W-T421-£M£-K ---
---
2
Version
Ver. 1.21 or later
---
---
---
Ver. 2.5.4 or later
---
Ver. 4.4 or higher
2-3