Omron CK3E Series Connection Manual page 26

3 EtherNet/IP Connection Procedures
3
Setting Connections 2 to 16
Set connections 2 to 16 in the same
way as described above.
For each connection, change the
Exclusive Owner number and other
data from 1 to up to 16.
For the Target Variable, set the value
in increments of +4, i.e., 768 is followed
by 772 for inputs and 769 is followed by
773 for outputs.
4
Select Device Bandwidth and make
sure that the bandwidth used by the de-
vice is within the specification range of
the PMAC.
5
Click the Transfer to Controller button.
•
If the message shown on the right
appears, click the Yes button.
•
If the message shown on the right
appears, select Change to
PROGRAM mode and execute the
transfer.
6
If the message shown on the right ap-
pears after completion of transfer, click
the Yes button.
*1. This value specifies the instance ID of the Assembly object. Refer to A-7-2 Assembly Object (Class ID: 04
Hex) in the CK3M-series Programmable Multi-Axis Controller Hardware User's Manual (Cat. No. O036) or
A-3-2 Assembly Object (Class ID: 04 Hex) in the CK3E-series Programmable Multi-Axis Controller
Hardware User's Manual (Cat. No. I610) for details.
3-12
CK3E/CK3M-series EtherNet/IP Connection Guide (O903)