Table of Contents
Advertisement
#
CAUTION:
• Clean all surfaces as soon as possible after boil overs or spillovers.
• Use warm soapy water only to clean the burner grates, cooktops, painted surfaces,
porcelain surfaces, stainless steel surfaces and plastic items on your range or
cooktop. DO not use grit or acid-type cleaners.
• Do not use steel wool, or abrasive cleaners, or acid type cleaners such as chlorine
bleach on your cooktop or grate systems.
cooktop. Use only non-abrasive plastic scrubbing pads.
• Do not allow foods containing acids (such as lemon or tomato juice, or vinegar) to
remain on porcelain or painted surfaces. Acids may remove the glossy finish.
Wipe up egg spills when cooktop is cool.
• Do not wash warm porcelain surfaces. Allow these areas to cool before cleaning.
You could burn yourself, or the porcelain could crack.
• Pitting and discoloration will result if spills are allowed to remain for any length of
time on stainless steel.
• Do not allow spillovers to remain on the burner caps. The caps could become
permanently stained.
• When cleaning around the burners, use care to prevent damage to the electrode (if
so equipped).
could damage or break the electrode. If this occurs, the burner will not light.
The owner's cooking habits and cleanliness will affect the operation of the range or cooktop.
Proper installation and care will help keep your range or cooktop looking and operating like new.
Most cleaning can be performed using normal household items.
RANGE & SLIDE-IN COOKTOP
1. To remove the range top:
a. Remove the hold down clip by sliding it forward from the front
burner. (Fig. 6-2)
b. Lift the top upward by the front edge. The top will "snap"
loose from the clips mounted in the burner box.
2. To replace the range top:
a. Lower the range top into place while centering the three holes
in the top around the burners.
b. The top must be centered around all three burners.
c. Apply downward pressure on both sides to "snap" the top into
place and secure the range top.
d. Slide the hold down clip under front burner. (Fig. 6-2)
3. To remove burner grates:
a. RV and CV Models - simply lift grate up and remove. Replace
by placing two legs at a time into the retaining grommets.
b. RA and CA model
• Grasp one side of the grate (left or right-hand side) and pull
straight up until grate "snaps" out of its retaining groove.
• To replace, place one side of the grate in the burner well,
ensure that the clip engages the emboss in the side.
• Gently press other end of the grate downward to "snap" the
grate into place. (Fig. 6-3)
Care and Maintenance
If a sponge or cloth should catch the metal igniter electrode, it
They will damage your range or
A
Fig. 6-2
Fig. 6-3
75
Advertisement
Table of Contents
