Qos Tab - Diffserv Port Binding; Qos Tab - Bandwidth; Figure 5-41: Qos - Diffserv Port Binding; Figure 5-42: Qos - Bandwidth - Linksys SRW2024P User Manual

24-Port 10/100/1000 Gigabit Switch with Webview and PoE
Add classes to a selected policy and set the Action, Meter, Rate, Burst and Exceed values using the drop-down
menus and fields provided then click Add.

QoS Tab - Diffserv Port Binding

This function binds a policy map to the ingress queue of a particular interface. You must first define a class map,
set an ACL mask to match the criteria defined in the class map, then define a policy map, and finally bind the
service policy to the required interface. You can only bind one policy map to an interface. The current firmware
does not allow you to bind a policy map to an egress queue.
Select Policy Map for a port from the drop-down menu.
Click Save Settings to save the changes.

QoS Tab - Bandwidth

This function allows the network manager to control the maximum rate for traffic transmitted or received on an
interface. Rate limiting is configured on interfaces at the edge of a network to limit traffic coming out of the
Switch. Traffic that falls within the rate limit is transmitted, while packets that exceed the acceptable amount of
traffic are dropped.
Rate limiting can be applied to individual ports or LAGs. When an interface is configured with this feature, the
traffic rate will be monitored by the hardware to verify conformity. Non-conforming traffic is dropped, conforming
traffic is forwarded without any changes.
Port. Displays the port or LAG number.
Status. Enables the rate limit (input or output) for the port or LAG. (Default: Disabled)
Rate Limit (Kbits/sec). Sets the rate limit level for the port or LAG. For Fast Ethernet ports the default is
100000Kbits/sec (Range: 64-100000). For Gigabit Ethernet ports the default is 1000000Kbits/sec (Range: 64-
1000000).
LAG. Indicates if ports are members of a LAG. To configure a rate limit for LAGs, go to the table entry for the LAG
number, which is listed after port g24 at the end of the table.
Set the Input Rate Limit Status or Output Rate Limit Status, then set the rate limit for individual interfaces or
LAGs, then click Save Settings.
Chapter 5: Using the Web-based Utility for Configuration
QoS Tab - Diffserv Port Binding

Figure 5-41: QoS - Diffserv Port Binding

Figure 5-42: QoS - Bandwidth

60