The Back Panel; Figure 2-2: Back Panel - Linksys SRW2024P User Manual

24-Port 10/100/1000 Gigabit Switch with Webview and PoE
Ports
LAN (1-24) The LAN (Local Area Network) ports connect to Ethernet network devices, such as
other switches or routers.
MiniGBIC (12) /MiniGBIC (24)The Switch is equipped with two mini-GBIC ports. The miniGBIC (gigabit interface
converter) port is a connection point for a miniGBIC expansion module, so the
Switch can be uplinked via fiber to another switch. If a Gigabit mini-GBIC port is
being used, the associated LAN port (12 and/or 24) cannot be used. They link to
high-speed network peripheral system or clients at speeds of 1000Mbps.
Use the Linksys MGBT1, MGBSX1, or MGBLH1 miniGBIC modules with the Switch.
The MGBSX1 and the MGBLH1 require fiber cabling with LC connectors, while the
MGBT1 requires a Category 5e Ethernet cable with an RJ-45 connector.
Console The Console port is where you can connect a serial cable to a PC's serial port for
configuration using your PC's HyperTerminal program. Refer to Chapter 4: Using
the Console Interface for Configuration for more information.

The Back Panel

The power port is located on the back panel of the Switch.
Power The Power port is where you connect the power cord.
Chapter 2: Getting to Know the Switch
The Back Panel

Figure 2-2: Back Panel

NOTE: If you need to reset the Switch, unplug
the power cord from the back of the Switch.
Wait a few seconds and then reconnect it.
4