Security Tab - Acl Binding; Figure 5-27: Security - Acl Binding - Linksys SRW2024P User Manual

24-Port 10/100/1000 Gigabit Switch with Webview and PoE
Dest. MAC Address. Matches the destination MAC address to which packets are addressed to the ACE.
Wildcard Mask. Defines the destination IP address wildcard mask.
VLAN ID. Matches the packet's VLAN ID to the ACE. The possible field values are 2 to 4094.
Ethernet Type. Specifies the packet's Ethernet type. This option can only be used to filter Ethernet II formatted
packets. (Range: 0-65535) A detailed listing of Ethernet protocol types can be found in RFC 1060. A few of the
more common types include 0800 (IP), 0806 (ARP), 8137 (IPX)
The Add to List button adds the configured MAC Based ACLs to the MAC Based ACL Table at the bottom of the
screen.
To remove an ACL rule, select an ACL rule from the table and click Remove. When all rules are removed from the
ACL the ACL is also removed.

Security Tab - ACL Binding

After configuring Access Control Lists (ACL), you should bind them to the ports that need to filter traffic. You can
assign one IP or MAC access list to any port.
You must configure a mask for an ACL rule before you can bind it to a port.
This Switch only supports ACLs for ingress filtering. You can only bind one IP or one MAC ACL to any port, for
ingress filtering.
Mark the Enable checkbox for the port you want to bind to an ACL. Select the required ACL from the drop-down
menu.
Port. Fixed port or SFP module. (Range: 1-24).
IP (Input). Specifies the IP Access List to enable for a port.
MAC (Input). Specifies the MAC Access List to enable globally.
Click Save Settings to save the changes.
Chapter 5: Using the Web-based Utility for Configuration
Security Tab - ACL Binding

Figure 5-27: Security - ACL Binding

47