Echo DCS-1600 Operator's Manual page 35

Troubleshooting table
Trouble
Red Charger light flashes or does not light up
Unit will not turn on
Unit does not run when turned on
Running time is too short
Chain oil does not come out
Unit vibrates excessively
Checking and maintenance requires specialist knowledge. If you are unable to check and maintain the product or deal with a
fault yourself, consult your dealer. Do not attempt to dismantle the product.
Consult your dealer in the event of a problem that is not covered in the table above, or other such concerns.
For spare parts and consumables, please use only genuine parts and designated products and components. Using parts from
other manufacturers or non-designated components may result in a malfunction.
Maintenance and care
Cause
Plug not connected to power
outlet
Battery not installed properly
Obstructed connection
Fault in the charger
Fault in the battery
Battery not installed properly
Battery discharged
Battery outside acceptable
temperature range
Battery outside acceptable
temperature range
Unit electronics too hot
Battery discharged
Cutting attachment dirty
Chain tension too hight
No oil in the oil tank
Clogged chain oil pipe or oil fil-
ter
Fault in the oil passage
Fault in internal parts
33
Solution
Plug in the charger
Check the battery installation
Reinstall battery again after re-
moving obstructions from connec-
tion
Consult your ECHO dealer
Consult your ECHO dealer
Check the battery installation
Charge the battery
Remove the battery and allow to
cool
Remove the battery and allow to
cool
Turn unit off and allow to cool
Charge the battery
Clean the cutting attachment
Readjust chain tension
Fill the chain oil
Clean the chain oil pipe and oil fil-
ter
Consult your ECHO dealer
Consult your ECHO dealer