Data Transmission - Samson 5757-7 Mounting And Operating Instructions

Data transmission

8 Data transmission
The TROVIS-VIEW software installed on your computer allows you to configure the controller
with electric actuator either in offline mode (device not connected to a computer) or in online
mode (device connected to a computer). To activate online mode, click on the device
toolbar. The communication port must be set (see section 8.1)
(direct data transmission)
Online mode
The actuator and TROVIS-VIEW are con-
nected constantly in online operation. Cur-
rent configuration and operating data are
uploaded from the actuator cyclically and
Connecting cable
displayed in TROVIS-VIEW. The settings
configured in TROVIS-VIEW can be directly
transferred to the controller with electric ac-
tuator.
To enable communication with the com-
puter, connect the serial interface (COM
Modular adapter
Memory pen
port) to the serial interface (RJ-12 jack) of
(also available separately:
the controller with electric actuator using a
order no. 1400-7697)
SAMSON connecting cable.
In case the computer does not have a serial Hardware package
order no. 1400-7704
interface, a USB/RS-232 adapter can be
used.
Offline mode (indirect data transmission)
There is no constant data communication
between the computer and actuator. Com-
munication must first be established to up-
load from the actuator or download data to
Memory pen – 64
the actuator.
order no. 1400-9753
Data can be transferred to the serial
interface over the SAMSON connecting ca-
ble or over a memory pen together with a
modular adapter.
A memory pen allows you to simply copy
and download configuration data onto
other devices.
US/RS-232 adapter
order no. 8812-0016
Fig. 14 · Accessories for data transmission
43
EB 5757-7 EN