Placing The Printer - Lexmark Optra Optra T Setup Manual

Caution!
Make sure your fingers are not under the printer when
you set it down. Use the handholds on the printer or
ask someone to help you lift it.
Handhold
Tab
Round hole

Placing the Printer

Square hole
Note: In order to ensure adequate clearance
when installing system board options,
see "Install Memory and Optional Cards"
on page 15 before you place the printer if
you plan to :
• install memory or option cards
and
• will have less than 605.6 mm (24 in.)
clearance on the left side of the printer.
1
Ask someone to help you lift the printer by
the handholds and lower it onto the duplex
unit, optional drawer, table or printer cabinet.
The tab, round hole and square holes on top
of any drawer or unit will help you seat the
printer so the edges are aligned properly.
Make sure the printer is securely in place.
To attach output options
If your printer supports output options, see:
• "Installing an Output Expander" on page 10
• "Installing a 5-Bin Mailbox" on page 12
• "Installing a High-Capacity Output Stacker"
on page 14.
Install Paper Options and Printer 7