Installing Printer Memory - Lexmark Optra Optra T Setup Manual

Keyhole
Tab

Installing Printer Memory

Warning!
Electronic components can be damaged by static electricity.
Touch something metal on the printer before you touch the
memory option.
Latch
Notch
16 Install Memory and Optional Cards
Tab
or Flash Memory
Memory connector 1
Memory connector 2
Memory connector 3
T616(n) and T614(n)
models only
Connection points
Latch
5
Use the tabs to slide the shield up until the
top three screws fit into the three keyholes
on the shield.
6
Hold the shield by the tabs and lift it off.
1
Follow the steps under "Accessing the
Printer System Board" beginning on
page 15.
2
Unpack the memory option. Avoid touching
the connection points along its edge. Save
the packaging materials.
3
Open both latches completely. Insert the
memory option straight into the connector
with the connection points pointing toward
the system board as shown.
4
Push the memory card firmly into the
connector until it snaps into place. Make
sure each latch fits over the notch located
on either side of the option card.
5
See "Reattach Shield and Close Doors"
beginning on page 18 to reattach the shield
and side door.