Reattaching the system board
access shield
Reattaching the side door
Install optional memory cards
17
1
Align the six keyholes on the shield
with the six screws on the system
board.
2
Press the shield against the
system board, and then slide the
shield to the right.
3
Tighten the six screws.
1
Align the three rear tabs on the
side door with the corresponding
slots on the MFP.
2
Guide the tabs on the top, bottom,
and front of the door into their
corresponding slots. The top and
front tabs snap into place.
3
Close the upper front door and the
multipurpose feeder door. Make
sure both doors snap closed on
both sides.