Lexmark X2470 User Manual page 23

Load up to
25 sheets of labels
50 transparencies
100 sheets of custom-size paper
Make sure
•
The print side of the labels faces you.
•
The top of the labels feeds into the printer first.
•
The adhesive on the labels does not extend to within 1 mm of the
edge of the label.
•
You use full label sheets. Partial sheets (with areas exposed by
missing labels) may cause labels to peel off during printing, resulting
in a paper jam.
•
The labels are loaded against the right side of the paper support.
•
The paper guide rests against the left edge of the labels.
Note: Labels require more drying time. Remove each sheet of labels as
it exits, and allow it to dry to avoid ink smudging.
•
The rough side of the transparencies faces you.
•
If the transparencies have a removable strip, each strip faces away
from you and down toward the printer.
•
The transparencies are loaded against the right side of the paper
support.
•
The paper guide rests against the left edge of the transparencies.
Notes:
•
Transparencies with paper backing sheets are not recommended.
•
Transparencies require more drying time. Remove each
transparency as it exits, and allow it to dry to avoid ink smudging.
•
The print side of the paper faces you.
•
The paper size fits within these dimensions:
Width:
–
76–216 mm
–
3.0–8.5 inches
Length:
–
127–432 mm
–
5.0–17.0 inches
•
The paper is loaded against the right side of the paper support.
•
The paper guide rests against the left edge of the paper.
23