Electrical System Maintenance; Electrical System Safety; Replacing The Fuses - Toro Pro Force 44553 Operator's Manual

Electrical System
Maintenance
Important:
Before welding on the machine,
disconnect the controller and the negative
cable from the battery to prevent damage to the
electrical system.

Electrical System Safety

•
Disconnect the battery before repairing the
machine. Disconnect the negative terminal first
and the positive last. Connect the positive terminal
first and the negative last.
•
Charge the battery in an open, well-ventilated
area, away from sparks and flames. Unplug the
charger before connecting or disconnecting the
battery. Wear protective clothing and use insulated
tools.

Replacing the Fuses

Engine
An in-line fuse (15A) is incorporated into the engine
wiring harness (Figure
1. Fuse block
Receiver
A fuse block is incorporated into the receiver wire
harness. It is located behind the receiver on the right
side of the control tower
1. Fuse
31
31).
Figure 31
(Figure 32).
Figure 32
g030098
g029821