Replacing The Remote Batteries - Toro Pro Force 44553 Operator's Manual

Replacing the Remote
Batteries
Battery specification: AAA (1.5 V)
Quantity: 4
1. Remove the 6 screws securing the cover halves
of the handheld remote together, and remove
the back cover (Figure
Note:
If possible, leave the rubber seal and
steel gasket in the channel when removing the
cover and batteries.
Figure 41
1. Screw
2. Back cover
3. Seal
4. Steel gasket
2. Remove the discharged batteries and properly
dispose in accordance with local regulations.
3. Observing battery polarity as shown in
42, insert the new batteries into the terminal
cradles.
Note:
When installing batteries, observe proper
polarity markings
onto the battery compartment to avoid damaging
the terminal cradles. You will not damage the
machine if you incorrectly installing the batteries
in the handheld remote, but the handheld remote
will not operate.
41).
5. AAA batteries
6. Lanyard pin
7. Lanyard ring
8. Front cover
Figure
(Figure 42) that are embossed
1. Positive battery polarity
g341770
4. Ensure that the steel gasket and rubber seal are
seated in the channel in the cover half and align
the back cover to the front cover
5. Align the lanyard ring over the lanyard pin
(Figure 41).
6. Assemble the back cover to the and front cover
with 6 screws
7. Torque the screws to 1.5 to 1.7 N⋅m (13 to 15
in-lb).
36
Figure 42
(Figure
(Figure 41).
g341771
g341769
41).