Electrical System
Maintenance
Important:
Before welding on the machine,
disconnect the controller and the negative
cable from the battery to prevent damage to the
electrical system.
Electrical System Safety
•
Disconnect the battery before repairing the
machine. Disconnect the negative terminal first
and the positive last. Connect the positive terminal
first and the negative last.
•
Charge the battery in an open, well-ventilated
area, away from sparks and flames. Unplug the
charger before connecting or disconnecting the
battery. Wear protective clothing and use insulated
tools.
Replacing the Fuses
Engine
A 15 A in-line fuse is incorporated into the engine wire
harness
(Figure
24).
1. Fuse
Receiver
An fuse block is incorporated into the receiver wire
harness. It is located behind the receiver on the right
side the of control tower
1. Fuse
27
Figure 24
(Figure
25).
Figure 25
g020717
g029821