Table of Contents
Advertisement
5.
Install the fuel line onto the fuel filter. Slide the
hose clamp close to the fuel filter to secure the
fuel line
(Figure
40).
Electrical System
Maintenance
Important:
Before welding on the machine,
disconnect the controller and the negative
cable from the battery to prevent damage to the
electrical system.
Electrical System Safety
•
Disconnect the battery before repairing the
machine. Disconnect the negative terminal first
and the positive last. Connect the positive terminal
first and the negative last.
•
Charge the battery in an open, well-ventilated
area, away from sparks and flames. Unplug the
charger before connecting or disconnecting the
battery. Wear protective clothing and use insulated
tools.
Fuses
Replacing the Engine Fuse
1.
Prepare the machine for maintenance; refer to
Preparing for Machine (page
2.
Near the starter motor, separate the halves of
the in-line fuse holder of the engine wire harness
(Figure
41).
1. Fuse
3.
Remove the open fuse from the fuse holder.
4.
Insert a new fuse (30 A) into the fuse holder.
5.
Assemble the halves of the in-line fuse holder
(Figure
41).
32
25).
Figure 41
2. Starter motor
g233945
Advertisement
Table of Contents
