Table of Contents
Advertisement
1
1 5
1. Mounting bolts
2. Pulley
3. Hole for torque wrench
2. Position a torque wrench into the pulley mounting
bracket (Figure 28).
3. Pivot the pulley mounting bracket away from the
nozzle until the torque wrench reads 200 to 230 in-lb
(22.6 to 26.0 N-m) (Figure 28).
4. Tighten the mounting bolts.
Electrical Maintenance
Important: Before welding on the machine,
disconnect the controller and the negative cable
from the battery to prevent damage to the electrical
system.
Fuse
A 15 amp in-line fuse is incorporated into the machines
wiring (Figure 29).
Figure 28
4. Torque wrench in pulley
mounting bracket [200
to 230 in-lb (22.6 to 26.0
N-m)]
5. Belt
2
3
4
1. Fuse
Fusible Link
A fusible link is incorporated into the machines wiring.
It is a grey wire located below the in line fuse.
G015845
Waste Disposal
Engine oil, engine and remote batteries are pollutants to
the environment. Dispose of these according to your
state and local regulations.
Storage
1. Turn the key to off. Remove spark plug wire.
Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine's cylinder head fins and blower housing.
Important: You can wash the machine with
mild detergent and water. Do not pressure wash
the machine. Avoid excessive use of water.
3. Service the air cleaner; refer to Servicing the Air
Cleaner.
4. Change the crankcase oil; refer to Servicing the
Engine Oil.
5. Check the tire pressure; refer to Checking the Tire
Pressure.
6. Charge the battery; refer to Servicing the Battery.
7. Prepare the machine for storage when non use
occurs over 30 days. Prepare machine for storage
as follows.
A. Add a petroleum based stabilizer/conditioner to
fuel in the tank. Follow mixing instructions from
24
Figure 29
Advertisement
Table of Contents
