Table of Contents
Advertisement
Installation
Page 10
Installation Checklist - Non Universal 120V Units
Install the cabinets by following these simple steps:
Mount the cabinets to the wall
Step 1
Hook up the feed/line wiring
Step 2
Hook up the load wiring
Step 3
Wire the Relay Cabinet (OPTIONAL)
Step 4
Hook up the control input wiring
Step 5
Hook up the fluorescent control wiring, if required
Step 6
Install the dimmer modules
Step 7
Verify the dimmers are in bypass mode
Step 8
Double check the wiring
Step 9
Power up the system
Step 10
Clear any faults that have caused any breakers to trip
Step 11
Set the bypass switch to normal
Step 12
Set up and Configure the control module
Step 13
Installation Checklist - Non Universal 277V and
Universal Units
Install the cabinets by following these simple steps:
Mount the cabinets to the wall
Step 1
Hook up the feed/line wiring
Step 2
Hook up the load wiring
Step 3
Wire the relay cabinet (optional)
Step 4
Hook up the control input wiring
Step 5
Hook up the fluorescent contorl wiring if required
Step 6
Install constant modules (optional) or dimmer modules
Step 7
If using universal modules verify the switches are in bypass mode
Step 8
Double check the wiring
Step 9
Power up the system
Step 10
Clear any faults that have caused any breakers to trip
Step 11
Disconnect power to cabinet if constant modules were installed
Step 12
Install the dimmer modules if constant modules were installed
Step 13
Set Bypass switches to normal if they were used
Step 14
Set up and Configure the control module
Step 15
- Quick Links:
- Programming/Function Buttons
Hide quick links:
Advertisement
Table of Contents
