Step 13E: Verifying Module Programming In A Dimmer Cabinet - Leviton a-2000 User Manual

Page 60
With the type flashing, press the DOWN
2
shows Function = Dimmer.
Press the Select/Save button.
3
Dimmer
Press the UP
4
LEVEL= 100%.
Press the Select/Save button to select the desired function.
5
Press the UP
6
level.
Press the Select/Save button.
7
Press the RIGHT
8
or press the Cancel/Clear button several times slowly to return to the
main menu.
Step 13E: Verifying Module Programming in a
Dimmer Cabinet
To determine how the modules are programmed in the dimmer cabinet, check the
module programming:
Make sure the powered on and in operating normally.
1
Press the UP
2
The LCD display shows
Press the UP
3
The LCD display shows
Press the SELECT button.
4
The LCD display shows how the first circuit of the first dual dimmer
is programmed.
Module programming information is displayed in a two-line format, as in the
following example:
Module number
Portion of dimmer set to this percent brightness
MOD 01A = 50% DM
INPUT=LUMANET S
Type of signal driving this half of module
(could be LUMANET or DMX512 or ANALOG in this case)
The above example indicates Module 01A, which is normally a dual dimmer, and
the A circuit of that dimmer is set to 50% of full brightness. DM indicates that it is
set up as a standard dimmer.
flashes.
or DOWN buttons until the LCD display shows MAX
or DOWN buttons to select the desired maximum
or LEFT button to move on to another circuit
button.
MENU SETUP
button again.
MENU MODULE STATUS
Percent of full brightness (FL for 100%)
Dimmer type
Whether dimmer can accept more than one
input type (blank if only assigned to one input type)
button until the LCD display
, with flashing.
MENU
.