Step 13A: Display At Startup; Potential Error Screens In The Main Menu; To Auto Assign Module Types; Step 13B: Verifying Phase Voltages - Leviton a-2000 User Manual

Page 54

Step 13A: Display at Startup

The main menu should appear like the menu below. It indicates the version of
a2000 Ver 2.00
STATUS=OK 1PHASE
software and if the voltage is single or three phase power.
If "Fault Condition" appears in lieu of "Status=OK", call Leviton's
Technical Service Department at 1-800-959-6004.

Potential Error Screens in the Main Menu:

Module Error
a2000 Ver 2.00
MODULE ERROR
If the system does not find the modules that were previously assigned, it will flash
"Module Error". To clear this message you must:
enter the set-up mode (or install the pre-assigned dimmers).
1
When you enter the set-up mode "Auto Assigning Module Types" will
2
appear.
Follow the procedure below
3

To Auto Assign Module Types:

When auto assign module type appears, push SELCT/SAVE to auto
1
assign the current module.
Once assigned press CANCEL/CLEAR to move on to the next module.
2
If the "auto assign module" appears again, repeat steps 1 and 2 for all
3
subsequent modules.

Step 13B: Verifying Phase Voltages

To check the phase voltages:
From the main menu Press the Select/Save button.
1
A=123V

Step 13C: Assigning Module Types

The control module and dimmer modules have auto sensing technology.
Regardless of where you insert a dimmer module the unit will set itself to the
B=121V
60 HZ