Rear Panel Cable Locations - Agilent Technologies 8360 B Series Service Manual

Refer to Figure 7-58.
5. Disconnect ribbon cable W31 from the motherboard.
6. Disconnect the 8-pin line switch connector.
7. Disconnect the fan harness.
8. Cut the tie wraps holding the coaxial cables to the four BNC connectors and the source
module interface.
9. Disconnect the coaxial cables from the A7, A10, A12, and A14 assemblies and disconnect
the source module interface cable from the A19 assembly.
Agilent 8360
Figure 7-58. Rear Panel Cable Locations
Disassembly and Replacement Procedures 7-71
Motherboard