Removing The Rear Panel - Agilent Technologies ESG Series Installation Manual
Hide thumbs
Also See for ESG Series:
- User and programming manual (446 pages) ,
- Quick start manual (31 pages) ,
- Manual supplement (31 pages)
Table of Contents
Advertisement
Removing the Rear Panel
1. Refer to Figure 4. Remove the nuts and washers securing the five BNC connectors (item 1) at the
base of the rear panel.
2. Remove the hex screws and washers that secure the AUXILIARY INTERFACE (item 2) and GPIB
connectors (item 3) to the rear panel.
3. Remove the 10 screws (item 4) that secure the rear panel to the signal generator chassis.
4. Pull the rear panel assembly away from the signal generator chassis.
Figure 4
Rear Panel View
Installation Note E4400-90388
9
Advertisement
Table of Contents
