Blower Motor Installation - Thermador HPCN36WS Installation Instructions Manual

Blower motor installation

⚠
CAUTION
To reduce the risk of fire and electric shock, install this
range hood only with the blowers listed in the Ventilation
Planning Guide.
NOTE: Cutting the plug of the blower will void the
warranty or eligibility for return or exchange.
Installing the integral blower
Integral blower models are integrated into the hood at the
time of installation. Integral blowers should be installed
after the hood is mounted to the wall. For complete
installation instructions, see the instructions supplied with
the blower unit.
NOTE: Blower and hood image views will vary depending
on model.
1. Thread one (x1) 4m flange nut (included with the
hood) half-way down each of the two weld studs
indicated.
2. Slide the blower mounting plate behind the nuts on
the weld studs.
15
3. Install two (x2) 4m flange nuts (included with hood) to
the top weld studs and tighten.
4. Tighten the two (x2) nuts from step 1 to fully secure
the blower to the hood.
5. Connect the blower's plug connector to the connector
present inside the hood.
6. Route the blower harness
through the self-locking clip.
Installing a remote blower or an in-line blower
For complete installation instructions see the instructions
supplied with the blower unit.
Remote blower
Depending on preference and ducting situation, these
blowers can be mounted on the roof or exterior wall of the
home. An exterior installation may be more appealing to
reduce noise in the kitchen.
inches (mm)
2 1 / "
8
(54)
3 / "
4
(20)
6 1 / "
2
(165)
12 7 / "
8
(327)
7 "
/
dia. 9
8
(dia. 251)
13 5 / "
8
(346)
1
12 / "
8
(308)
10"
3
20 / "
4
(254)
(527)
7
19 / "
8
(505)