Make-Up Air Damper Relay Switch (Optional); Remote Control Installation (Optional) - Thermador HPCN36WS Installation Instructions Manual

Make-up air damper relay switch
(optional)
Local codes may require the use of an additional backdraft
and/or make-up air damper. Contact your local HVAC
professional for specific requirements.
This hood provides a relay switch to connect a make-up air
damper (120V max). Installations will vary according to the
location in the home where the unit is installed and the
damper used. Use the following illustration as guidance
for your installation. Always comply with local code
requirements.
To connect the make-up air damper relay switch
1. Access the hood's wiring.
2. Route the make-up air damper harness through the
strain relief to the terminal block.
• The make-up air kit hot and return connections
can use either terminal connection. There is no
polarity requirement for the two pin terminal
block.
3. Secure the ground wire with the green T-20 ground
screw.
Built-in remote control accessory
(optional)
IMPORTANT: Cutting off a connector to the appliance or
to the extension cable kit will void the warranty.
Before you begin, read these instructions carefully. It is
recommended that the remote control be wired to the
hood after the hood is installed.
REMCPW parts included
• 1 – remote control
• 1 – 30 ft. extension harness
17
Installing the remote control
1. Prepare the wall (or similar surface) cutout for
installation as shown below (view is shown facing wall).
5 / "
2
8
(65)
2. Access the hood's wiring. Route the 30 ft. extension
harness through the strain relief to the square
mounting clip until it clicks.
3. Route the 30 ft extension harness through the cutout
and connect the harness to the back of the remote
control bracket.
4. Press the bracket inside the cutout. Drill a ¼'' (6 mm)
tap hole through the bracket holes into the wall.
Mount the bracket to the wall using the four (4) screws
provided.
inches (mm)
5
/ "
13
8
(346)
inches (mm)