Installation Instructions; Blower Motor Installation - Thermador VCIN36JP Installation Manual

Installation Instructions

Blower Motor Installation

Blower SKU
Integral VTN630* 120
Integral VTN1030* 120
Remote VTR630* 120
Remote VTR1030* 120
Remote VTR1330* 120
Inline VTI610* 120
Inline VTI1010* 120
* Indicates a letter designating the release year.
** With blower installed.
Integral blower installation only
1. The blower is attached to the hood using weld studs on
the mounting plate. Figure 6 exhibits the weld stud
locations.
2. Guide the motor mounting plate over the studs.
3. Attach four (4) nuts (included with hood) to the weld
studs. Tighten nuts to secure the blower to the hood.
Weld Studs
x 4
English 10
Blower **Circuit
Voltage
Current Breaker
(Ac)
(Amps) (Amps)
2.7 15
5.4 15
4.2 15
5.7 15
8.5 15
4.2 15
5.7 15
Figure 6: Weld Stud Location
Knockouts
25 ft. Blower Cable Connection Accessory
(optional)
Kit
The blower extension cable is compatible with the
following Inline & Remote blowers:
Blower
Remote Blower
Remote Blower
Remote Blower
Inline Blower
Inline Blower
*Indicates a letter designating the release year.
EXTNCB25 Parts Included
1 – 25 ft. cable
1 – Adapter Cable No. 1
(NOT NEEDED FOR VCIN OR
VCIB MODEL CONNECTIONS)
1 – Adapter Cable No. 2
(NOT NEEDED FOR VCIN OR
VCIB MODEL CONNECTIONS)
IMPORTANT: CUTTING OFF A CONNECTOR TO THE
APPLIANCE OR TO THE EXTENSION CABLE KIT
WILL VOID THE WARRANTY.
Junction Box
Figure 7: Junction Box Location
SKU
VTR630*
VTR1030*
VTR1330*
VTI610*
VTI1010*