Securing The Hood Assembly; Blower Motor Installation - Thermador Professional HPIN54WS Installation Manual

en-us Installation
5.3 Securing the hood assembly
Using two people, lift the assembled range hood to the
1.
support frame. Slide the lip of the side panel into the
support sleeve of the support frame.
2.
CAUTION DO NOT hang the hood on the support
sleeve without use of the screws for long periods of
time. The support sleeve is not designed to bear the
weight of the hood.
Secure the range hood to the support frame with four
(4) ½'' (25.4 mm) screws into the left and ride sides.
5.4 Blower motor installation
CAUTION
To reduce the risk of fire and electric shock, install this
range hood only with the blowers listed in the Ventilation
Planning Guide.
Note: Cutting the plug of the blower will void the warranty
or eligibility for return or exchange.
Installing a remote blower or an in-line blower
Depending on preference and ducting situation these
blowers can be installed outside the kitchen. This reduces
the noise in the kitchen. For complete installation
instructions see the instructions supplied with the blower
unit.
14
Remote blower
1.
Remote blowers can be mounted on the roof or exterior
wall of the home
In-line blower
2.
In-line blowers can be mounted along the duct line
anywhere between the kitchen and the exterior wall, if
there is easy access to duct line, e.g. in an attic.
Remote and in-line blower motor wire connection:
3.
Route the blower motor's plug connector to the hood.
‒
Connect the blower's harness to the hood harness.