Blower Motor Installation - Thermador VCIN36WS Installation Instructions Manual

c) Install strain relief (not included) into one of the
circular knockouts.
6. Install the unit.
a) Install the custom insert inside the custom
housing.
b) Secure to the rear of the housing framework using
six (6) x 1'' (25.4 mm) mounting screws, as
indicated below.
c) Secure to the top of the housing framework using
eight (8) x 1'' (25.4 mm) mounting screws, 4 per
side.
7. Connect to the ductwork.
8. Install the blower motor.
a) Refer to "Choosing the correct blower" on
page 10.
b) Refer to "Blower motor installation" beginning on
page 12.
9. Connect the electrical wiring.
12
a) Connect wiring for applicable blower motor (see
blower instructions beginning on page 12).
10. Install hood filters and grease trays.
a) Refer to "Installing grease trays and filters" on
page 16.
11. Test the installation.
a) Test the operation of the blower and the lights.
b) Be sure to check for back-draft. With the blower
on high, close the windows and doors to the area
to ensure that fan does not cause back drafting in
any outlet vent for another appliance.

Blower motor installation

9 CAUTION
To reduce the risk of fire and electric shock, install this
range hood only with the blowers listed in the Ventilation
Planning Guide.
NOTE: Cutting the plug of the blower will void the
warranty or eligibility for return or exchange.
Installing the integral blower
Integral blower models are integrated into the hood at the
time of installation. Integral blowers should be installed
after the hood is mounted to the wall. For complete
installation instructions, see the instructions supplied with
the blower unit.
NOTE: Blower and hood image views will vary depending
on model.
1. Thread one (x1) 4m flange nut (included with the
hood) half-way down each of the two weld studs
indicated.