Installer Setup - Robertshaw RS10420T Installation Manual

1. Press MENU.
2. Press and hold TECHNICIAN SETUP for 3 seconds.
3. Configure the installer options as desired using the table below.
4. Use or to change settings and the NEW STEP or PREV STEP to move from one
step to another. Note: Only press DONE when you want to exit the Installer Setup options.
Settings
Setup WiFi
WiFi router parameter configuration
This setting will flash FILT in the
display after the elapsed run time
Filter Change
to remind the user to change the
Reminder
filter. The OFF setting will disable
this feature.
This setting allows the installer to
Room
change the calibration of the room
Temperature
temperature display so that, for
example, the thermostat would read
Calibration
74°F instead of 70°F.
Display Adjustment Options
The filter change reminder can be
adjusted from OFF to 2000 hours
in 50 hour increments. Press the
second button from the top left side
of the thermostat to display the
current filter elapsed run time.
The room temperature display
can be adjusted to read 4° above
or below the factory calibrated
temperature.

INSTALLER SETUP

Default
OFF
0
11