Cooper HALO HC8R Installation Instructions Manual page 2

Installation Instructions – HC8R/HC812R Recessed LED Retrofit
Retro-fit Kit Contents:
Retrofit Ring Assembly
●
Retrofit Driver Assembly
●
HM8 LED Module (Sold Separately)
●
81 LED Reflector (Sold Separately)
●
Tools Required (optional):
Flathead screwdriver (from others)
●
INSTALLATION
Retrofit Driver Assembly
For Horizontal Compact Fluorescent Housings:
Connecting the module and trim
Attach reflector to LED module using side clips.
Installing this assembly in the ceiling
1. Remove existing reflector/trim and lamp (Figure 1).
2. Remove reflector mounting hardware from mounting
bracket (Figure 2).
3. Locate junction box, remove ballast/junction box cover
and disconnect supply wires (120 or 277). Disconnect
connections to insulation detector if any. Disconnect all
wires from the socket to the ballast (wire colors may
vary) (Figure 3).
4. Remove one 7/8" diameter (1/2" trade size conduit)
knockout from junction box, on top if possible.
5. Place retrofit driver assembly through ceiling/housing
opening (Figure 4).
6. Lay retrofit driver assembly away from ceiling/housing
opening with driver side up (Figure 5).
7 . Leave flexible conduits from retrofit driver assembly
hanging down out of ceiling/housing opening.
8. Feed supply wires from retrofit driver assembly through
knock-out that was removed in junction box and insert
snap-in connector into junction box
(Figure 6).
9. Reconnect supply wires in junction box to leads from
retrofit driver assembly: black wire to line, white wire to
neutral, green wire to ground and any dimming leads as
necessary (see Wiring Diagrams).
10. Replace ballast/junction box cover to completely close
junction box.
2
COOPER LIGHTING SOLUTIONS
IB517061ML Installation instructions
Retrofit
Assembly
Retrofit Ring
Assembly
Adapter Ring
(Optional)
HM8 LED Module
(Sold Separately)
Figure 1.
Figure 3.
Figure 5.
Retrofit Ring
Assembly with
12 inch Fixture
Adapter Ring
81 LED Reflector
(Sold Separately)
Figure 2.
Figure 4.
Figure 6.