Programming The Foot Control; Embroidery Settings; Adjusting The Upper Thread Tension - Bernina 570 QE User Manual

Programming the Foot Control

If «Needle Up/Down» is activated, the needle is raised or lowered with the back-kick on the foot control.
Alternatively, the presser foot can be positioned, the thread can be cut and the automatic securing can be
programmed.
> Tap «Home».
> Tap «Setup Program».
> Tap «Sewing Settings».
> Tap «Programming the Foot Control».
– «Needle Up/Down» is activated in the default setting.
– The back-kick on the foot control raises or lowers the needle.
> To program the Back-kick, tap «Programming the Back-kick».
> To deactivate the automatic securing via the Back-kick, tap «Securing Stitches».
> To activate the automatic securing via the Back-kick, tap «Securing Stitches» again.
> To program subsequent securing stitches, tap «Securing Stitches in Close Succession».
> To program the number of securing stitches, tap «Minus» or «Plus».
> To program 4 securing stitches in place, tap «Securing Stitches in Place».
> To deactivate the automatic thread cut via the Back-kick, tap «Automatic Thread Cutter».
> To activate the automatic thread cut via the Back-kick, tap «Automatic Thread Cutter» again.
> To keep the lowered position of the presser foot via the Back-kick, tap «Raise the Presser Foot».
> To keep the raised position of the presser foot via the Back-kick, tap «Raise the Presser Foot» again.

3.2 Embroidery Settings

Adjusting the Upper Thread Tension

Changes to the upper thread tension in the Setup Program affect all of the embroidery designs. The setting
in the Setup Program is retained after the machine is switched off.
Setup Program
55