Security Kit Installation Procedures - Kyocera Data Security Kit (B) For Copier Operation Manual

Security Kit Installation Procedures

Step 1: Preparation
Security Kit installation
The Security Kit is installed by service representative.
Precautions for Security Kit installation
• The repeat copy function becomes prohibited.
• The Delete Invalid Data menu is replaced by the Format Hard Disk menu.
Precautions for installing the Security Kit on a pre-used copier
After installing the Security Kit, you must format all hard disks.
Step 2: Changing the Management code
The management code must be entered to use the Security Kit. Changing the
management code prevents everyone except the administrator from using the
Security Kit. The management code is eight digits long when using security
mode.
Important!
Avoid using a management code that is easily guessed, such as 11111111 or
12345678.
Note
You can change the management code within the range of 00000000 to
99999999.
Be sure to use eight digits.
Press the Default Setting/Counter key.
1
Press the Machine Default key.
2
3 Use the numeric keys to enter the current management code. The factory
default numbers are 80008000 for 80 cpm model and 60006000 for 60 cpm
model.
Select Management code change from the left side setup field, and press
4
the Change # key.
Administrator Information
1-13