Glossary - Kyocera KM-1815 Advanced Operation Manual

Appendix

Glossary

AppleTalk
AppleTalk offers file sharing and printer sharing and it also enables you to utilize application
software that is on another computer on the same AppleTalk network.
APS (Auto Paper Selection)
When you want to copy from various sizes of originals at one time, this mode will automatically
select the size of copy paper that corresponds to each individual original and will copy that original
onto the paper size.
Auto Sleep
This mode is activated after a specified amount of time elapses. The machine goes into an economy
mode and a minimum amount of power is consumed. You can use the operation panel to change
the amount of time before the machine goes into the Auto Sleep. The default setting is 30 minutes.
COMMAND CENTER
This is the home page that is installed in this machine. It can be accessed from a Web browser by
simply entering the appropriate IP address. You can then use the browser window to verify the
machine's operating status and make settings related to security, network printing, e-mail
transmission and advanced networking.
DHCP (Dynamic Host Configuration Protocol)
This is a protocol that automatically resolves the IP address, Subnet Mask and Gateway address on
a TCP/IP network. Use of DHCP minimizes the load of network administration, especially on
network environments with a large number of client computers where it is not specifically necessary
to assign a separate IP address to each client, including printers.
dpi (dots per inch)
This indicates the number of dots printed per inch, and is the unit of printer and scanner resolution.
EcoPrint
This is a printing mode that controls toner consumption. Pages printed in the EcoPrint mode are
lighter than pages printed in the normal mode. The default setting is Off.
Emulation
This refers to emulation of other manufacturers' printers. The printer emulates operation of the
following printers: PCL6, Line printer, IBM Proprinter, DIABLO 630, EPSON LQ-850 and KPDL.
Expansion Memory
This option is used to increase machine memory. The printer has one expansion slot, and you can
install a 64 MB, 128 MB, or 256 MB DIMM (Dual Inline Memory Module). Contact your dealer to
purchase the DIMM that is best suited for use with this machine.
Face-up Tray
This is located at the rear of the machine. Select paper output to the face-up tray when printing on
postcards, envelopes, or labels.
Form Feed Timeout
During the time that data is being sent to the printer, periodic pauses or interruptions may be
generated. However, even if the data stream is interrupted, the printer can normally handle the next
data that is sent after a delay without making a page break between the two blocks of data. Form
Feed timeout is a function that waits only a pre-determined amount of time before it executes just
such an automatic page break. After the waiting period begins, once the predetermined time is
exceeded, the printer will automatically process the currently received data and print it out. If there is
no further print data for the last page, the printer will end processing of that job.
Appendix-14