Installing In Custom Mode With A Network Connection Using Custom Select - Kyocera ECOSYS FS-3140MFP Driver Manual

Installing in Custom Mode with a Network Connection using
Custom Select
1
2
3
4
5
6
7
8
9
Printer Driver
Click Finish, and retry the installation. If the same message appears again,
contact your system administrator.
The installation of the printer is now complete. If prompted, restart your
computer.
This section describes the custom installation procedure of the driver software
in Windows operating systems using a network connection.
Ensure that your printer and computer are connected to a network.
On the Installation Method page, select Custom Mode.
The Discover Printing System page opens, searching for your printing
system. The Discover button is automatically selected. Choose Custom select
and click Next.
The Printing System page appears. Select your printing system model from
the list and click Next. If there is only one driver model, this page does not
appear. Proceed to the next step.
On the Printer Port page, select the port connected to your printing system, or
add a port connected to your system by clicking Add Port. Click Next.
On the Custom Installation page, select the driver and software packages you
want to install from the Driver and Utility tabs, and clear those not intended for
installation. Click Next.
If you only select software packages from the Utility tab, you will skip to the
Confirm Settings page.
On the Printer Settings page, you can assign a name for your printing system.
You can also choose to share this printer with others or set this printer as the
default printer. Make your selections, and then click Next.
On the Confirm Settings page, click Install if the settings are correct. Click
Back to correct the settings.
Note: In Windows XP, or Windows Server 2003, if the Hardware Installation
warning dialog box appears, click Continue Anyway. In Windows 7, Windows
Vista, or Windows Server 2008, if a warning dialog box appears stating
Windows can't verify the publisher of this driver software, click Install this
driver software anyway.
The Installation Completed page appears displaying the following driver
options.
Print a test page
This selection verifies a connection with the printer and creates a print out of
the installed driver components.
Enable Status Monitor
Installation
1-7