Using Adcpro With The Ads126Xevm; Loading The Ads1262Evm Plugin In Adcpro; Evm Connection Status - Texas Instruments ADS126 EVM-PDK Series User Manual

ADS126xEVM Software
3.3

Using ADCPro with the ADS126xEVM

For more information about ADCPro than is provided in this document, refer to the ADCPro User's Guide,
SBAU128. This section covers only the functionality of the ADS126xEVM plugin. After the hardware is
connected, powered up, and ADCPro is running, follow these steps to establish communication with the
ADS126xEVM:
1. Load the ADS126xEVM plugin by clicking ADS126XEVM from the EVM file menu shown in
This step can be repeated to reload the plugin. The plugin may need to be reloaded in the case of a
communication failure or if power is cycled on the EVM hardware.
2. Wait for the Connected to EVM status seen in
either by pushing the reset button in the upper right corner of the MMB0 or by cycling MMB0 power. If
a connection cannot be established after resetting the MMB0, refer back to
for the required drivers and hardware connections.
18
ADS126xEVM-PDK
Figure 13. Loading the ADS1262EVM Plugin in ADCPro
Figure 14. EVM Connection Status
Copyright © 2015, Texas Instruments Incorporated
Figure 14. If the connection fails, reset the hardware
www.ti.com
Figure 13.
Section 3.1 and Section 3.2
SBAU206 – April 2015
Submit Documentation Feedback