Table of Contents
Advertisement
www.ti.com
3. Configure the ADS126x. The ADS126xEVM plugin is divided into ten tabs, as shown
Clicking on a tab changes the displayed controls. The controls on each tab are described in
Section
3.4.
4. Select a test plugin from the Test file menu, as shown in
3, but is required before acquiring data in the next step.
5. Acquire data by clicking the Acquire or Continuous button (previously shown in
buttons are only operational when both the EVM and test plugins are loaded. Clicking Acquire captures
a single block of data. Clicking Continuous captures blocks of data repeatedly. The block size is
configured in the test plugin.
6. Use the test plugin functions as described in the ADCPro User's Guide, SBAU128, to analyze the ADC
conversion data.
SBAU206 – April 2015
Submit Documentation Feedback
1 Input MUX
7 Data \ MODE
2 Reference
8 Calibration
3 Digital Filter
9 Register Map
4 IDAC / Sensor Bias
5
GPIO
10 Extras / About
6
Test DAC
Figure 15. ADS1262EVM Plugin Tabs
Figure 16. Loading a Test Plugin in ADCPro
Copyright © 2015, Texas Instruments Incorporated
ADS126xEVM Software
Figure
16. This step may precede steps 1 to
Figure
ADS126xEVM-PDK
inFigure
15.
14). These
19
Advertisement
Table of Contents
