Using Hole Punch - Kyocera KM-C830D User Manual

Finishing
1
2
3
4
5
6
1
2
5-3

Using Hole Punch

From the application's Print dialog box, open Properties. (Select Print from the File
menu, and select Properties.)
In the Basic tab, under Destination, select a face up or face down finishing tray.
Click the Finishing tab, then select Punch.
Select the number of hole punches: 2 hole, 3 hole, or 4 hole. Available punch options
are set in the Device Settings tab and depend on the punch unit installed. For further
details, refer to Installing Optional Devices
positioning the hole punches, refer to
• For metric specification, use 2 hole and 4 hole punch options.
• For inches specification, use 2 hole and 3 hole punch options.
Click OK to return to the Print dialog box.
Click OK to start printing.
The print job will be punched by the finishing device and delivered to the output tray.
For further details about hole punch specifications, refer to your finishing device's
Operation Guide.
Positioning the Hole Punch
Note: Some models do not support the punch position option.
With Punch selected in the Finishing tab, click the Settings button.
In the Punch Position Settings dialog box, select where to place the hole punches
on the page: Left, Right, or Upper.
on page 2-1. For information on
Positioning the Hole Punch
1
2
3
below. 4
5
6
1
2
KX Driver