Kyocera FS-C5016N Installation Manual

FS-C5016N

Installation Guide

Unpacking
Unpack the printer and all its included components.
1
European/Pacific U.S.A./Canada
countries
Avoid installing the printer on unstable surfaces and surfaces that are not level.
Installing the Toner Containers and Waste Toner Box
Close the paper transfer
4
unit tightly.
Note
Be sure you set the toner
container in the correct location
for that color.
Magenta (M)
Cyan (C)
Yellow (Y)
Black (K)
Open the left cover.
11
Making Connections
Connect the printer to your computer. (The connecting
15
cable is sold separately.)
USB Interface
Parallel
Interface
Network Interface
(Ethernet)
2
Be sure to hold the
right and left sides
of the printer when
carrying it, as shown
in the illustration.
Rear
Open the top cover and remove
5
the packing item.
Packing
Item
In this example, it is assumed that you are
installing the black toner container.
Install the toner container by
8
pushing down on the container
until it clicks firmly into place.
Open the cap of the waste
12
toner box.
Cap
16
Important!
Kyocera Mita assumes no liability for any damage caused by an improper
installation of the printer.
Checking Parts and Components
Remove the
packing cover and
all packing tapes.
Packing Cover
Packing
Tape
Make sure that the side of the toner
6
container with the markings (caution
notes, etc.) are facing downward,
and shake the new toner container 5
or 6 times as shown in the figure in
order to distribute the toner evenly
inside the container.
DO NOT forcefully push in on the center of the
toner container or touch the toner supply opening
with your hands or fingers during this procedure.
Apply light pressure to the toner
9
container and push the blue lock
lever on the toner container back
towards the locked symbol ( ) as
far as it will go.
To install the other color toner containers,
use the same procedure as above.
Install the waste toner box into the
13
printer as shown in the figure by
setting the bottom of the box into
the receptacle, and then pushing
down on the box until it snaps firmly
into place.
Connect the provided power
cord to a power outlet.
Power Cord
Connecter
Continued on
the Reverse Page Basic installation is now complete. Before using the printer, refer to "Setting the Color
Registration" on the reverse page and use the printer's operation panel to perform the color
registration procedure.
8
3
7
3 4
1 Printer 3 Magenta Toner Container
2 Documents and Software 4 Cyan Toner Container
• Installation Guide 5 Yellow Toner Container
(This sheet) 6 Black Toner Container
• Quick Reference Guide 7 Waste Toner Boxes
• CD-ROMs
8 Power Cord
Set the new toner container in
7
the printer with the markings
facing upward as shown in the
figure below.
Toner Supply
Opening
Close the top cover.
10
Lock Lever
Make sure that the waste toner
14
box is correctly inserted and
close the left cover.
Turn on ( | ) the printer's power
17
switch (located on the rear side
of the printer).
1
2
5 6
(One is spare.)