Path Mode Graphics Commands; Command Function Page - Kyocera KM-1500 Command Reference Manual

PRESCRIBE Command Reference

Path Mode Graphics Commands

6
If an attempt is made to create figures outside of the printable area using these
commands, the coordinates are adjusted automatically so that the figures print inside the
printable area. As in the example below, this can produce printed results different from
what is expected.
Print settings according to command
Printing extremely complex figures can exhaust printing system memory. Downloadable
fonts can be particularly taxing on printing system memory, producing unexpected print
results. It may be possible to correct the problem by removing some of the downloaded
fonts or by simplifying the graphic. To determine current memory usage, refer to a status
page.
Command Function
ARC draw filled-in ARC
BLK draw filled-in BLocK
BOX draw BOX
CIR draw CIRcle
DAP Draw to Absolute Position
DPAT select Dashed PATtern
DRP Draw to Relative Position
DRPA Draw to Relative Position specified by Angle
DZP Draw to Zero-relative Position
FPAT generate Fill PATtern
GPAT set Gray PATtern
PAT select fill PATtern
PIE draw PIE chart
SPD Set Pen Diameter
XPAT generate eXpanded fill PATtern
The following commands provide a variety of path construction operators and painting
operators for stroking or filling paths.
Command Function
CLIP CLIP current path
CLPR CLiP Rectangular area
CLSP CLoSe Path
CPTH Character PaTH
Actual printed result
Page
27
39
41
51
72
77
79
81
86
109
121
182
197
314
389
Page
53
54
56
63