Arc - Draw Filled-In Arc - Kyocera KM-1500 Command Reference Manual

ARC —
draw filled-in ARC
Format
Parameters
inner-radius:
outer-radius:
start-angle:
end-angle:
Function
ARC inner-radius, outer-radius, start-angle, end-angle;
inner radius of arc
outer radius of arc
starting angle
ending angle
The ARC command works in the standard graphics mode. It draws a filled-in arc-shaped
area extending from the inner radius to the outer radius, and from the starting angle to the
ending angle. The area is filled with the pattern designated by the previous PAT, FPAT, or
GPAT command. The starting and ending angles are specified in integer degrees
measured clockwise from the vertical. (Note that the PARC command measures the
angles from the positive x axis.) The cursor is located at the center of curvature of the
arc, and does not move.
If the inner radius is zero, the area has a pie-slice shape, and can be used to fill in one
sector of a pie chart.
If the inner and outer radii are nearly equal and the fill pattern is the all-black pattern
(PAT 1, for example), the result is a line arc. The line thickness is the difference between
the two radii, rather than the value designated by the SPD (set pen diameter) command.
The ARC command does not draw the boundary of the filled-in area.
ARC
27