Setting The Date And Time; Playback Of Messages - ClearSounds Photo50 V608 Owner's Manual

In Toll Saver mode incoming calls are answered after six rings until
the first new message has been recorded. once a message has been
recorded the answering machine will answer after approximately
two rings.
This is useful when trying to remotely access the answering machine;
if the answering machine has not answered at the fourth ring, no
messages have been recorded and you can hang up before you are
charged for the call.
If the machine answers after two rings new messages have been
recorded.

Setting the date and time

press and hold the SKIP button for 2 seconds. The system announces
Sunday.
press the SKIP button repeatedly until you hear the correct day of
the week.
confirm by pressing the PLAY button, the system will announce "0"
press the SKIP button repeatedly until you hear the correct time
confirm by pressing the PLAY button, you will hear the minutes
currently set.
press the SKIP button until you hear the correct minutes
announced.
confirm by pressing the PLAY button and the complete day and time
will be announced.
You can check the day and time setting at any time by pressing the
SKIP button.
Note: In case of a power failure the date and time must be reset

Playback of messages

The display flashes to show how many new messages have been
received. If no new messages have been received the display shows
total messages (old).
Playback will always begin with any new messages. For example if
there are three old messages and two new ones, only the two new
ones will be played back, then the answering machine will return to
standby mode.
press the play button once again to listen to all messages, starting
with the oldest messages.
1 Press PLAY to start playback. If you want to pause during playback
9 – ENGLISH