Remote Code; Remote Control; Command Functions - ClearSounds Photo50 V608 Owner's Manual

This three-digit remote code is required in order to gain access to
the remote functions of the answering machine. The remote code is
printed underneath the machine.
1 call up the answering machine.
2 While the outgoing message is playing, enter the remote code. If
the code is accepted, you will hear two beeps.
3 Select a remote control command (within 20 seconds) from below.
4 When you have finished accessing the machine replace the handset.
25 ....................... play new messages
2# ...................... play all messages
3# ...................... Erase single message during playback
6# ...................... Skip to previous message
7# ...................... Skip to next message
8# ...................... repeat message
## ..................... Stop playback
3# ...................... Erase all messages
7# ...................... record a new outgoing message, to Stop
8# ...................... record a MEMo, to Stop recording press 8#
9# ...................... Turn the answering machine either On or Off.
0# ...................... room monitor, press 5# to stop the room
NOTE: If the machine doesn't respond correctly to the remote
control commands, try pressing the telephone buttons for a longer or
shorter time. In normal cases, the answering machine should react
to tones approximately 0.5 – 1 seconds in length, but longer tones
may be necessary. If you do not enter any remote control command,
the answering machine will disconnect after a few seconds.
If you listen to any incoming messages for more than 2 minutes and

remote code

remote control

command functions

During playback:
after playback:
recording press 7#again.
again.
Three beeps indicate Off- Two beeps indicate On.
monitoring.
11 – ENGLISH