Table of Contents
Advertisement
TM_i-BX(-N)_NC05_00_06_20_EN
2.3
AMBIENT THERMOSTAT
The interface that can be used with zone control (accessory) is an N-THC graphic display.
The N-THC interface is used for zone control and is specific for i-BX-N units. The N-THC thermostat for i-BX-N units requires 230 Volt power supply.
By connecting two N-THC in series to connector 4 (see chapter HARDWARE) of the controller and using the Modbus protocol it is possible to control
2 zones (1 high temperature and 1 low temperature zone). Control of each individual system zone will be possible through this interface.
Dimensions
2.3.1
AMBIENT THERMOSTAT ADDRESSING PROCEDURE
1 Initial display
4 Press the knob to confirm the password
MEHITS S.p.A.
●
TECHNICAL MANUAL
Connections
2 Press at the same time for
3 seconds keys
+
5 Press the knob
14
3 Rotate the knob and select the user
password: 22
6 In succession:
A Rotate the knob to select the value
B Press the knob to confirm
Version NC05 - Translation of the Original Instructions
Advertisement
Table of Contents
