Table of Contents
Advertisement
Failure to log out of iLO by browsing to a different site or closing the browser window results in an idle connection.
The iLO firmware supports a finite number of connections. Misuse of the Infinite timeout option might make iLO
inaccessible to other users. Idle connections are recycled after they expire.
This setting applies to local and directory users. Directory server timeout settings might pre-empt the iLO setting.
Changes to the setting might not take effect immediately in current user sessions, but will be enforced immediately in
all new sessions.
iLO Functionality
Specifies whether iLO functionality is available.
When this setting is enabled (default), the iLO network is available and communications with operating system
drivers are active.
When this setting is disabled, the iLO network and communications with operating system drivers are terminated.
To re-enable iLO functionality, use the UEFI System Utilities. For more information, see the UEFI System Utilities user
guide.
iLO functionality cannot be disabled on ProLiant server blades or Synergy compute modules.
iLO Web Interface
Specifies whether the iLO web interface can be used to communicate with iLO. This setting is enabled by default.
iLO RIBCL Interface
Specifies whether RIBCL commands can be used to communicate with iLO. This setting is enabled by default.
RIBCL over HTTP/HTTPS, RIBCL through in-band communication, and RIBCL through the OA port do not work when
this feature is disabled.
This option must be enabled when you register a server for Insight Remote Support central connect or Remote
Support from HPE OneView.
The following message is displayed if you try to use RIBCL when it is disabled:
<?xml version="1.0"?>
<RIBCL VERSION="2.23">
<RESPONSE
STATUS="0x00FC"
MESSAGE='RIBCL is disabled.'
/>
</RIBCL>
iLO ROM-Based Setup Utility
Enables or disables the iLO configuration options in the UEFI System Utilities.
When this setting is enabled (default), the iLO configuration options are available when you access the UEFI System
Utilities.
When this setting is disabled, the iLO configuration options are not available when you access the UEFI System
Utilities.
This setting cannot be enabled if option ROM prompting is disabled in the system BIOS.
This option is called iLO 5 Configuration Utility in the UEFI System Utilities.
Require Login for iLO RBSU
Determines whether a user credential prompt is displayed when a user accesses the iLO configuration options in the
UEFI System Utilities.
When this setting is disabled (default), login is not required when a user accesses the iLO configuration options in the
UEFI System Utilities.
Set up HPE iLO on the HPE ProLiant e910t Server Blade
31
Advertisement
Table of Contents
