Storage; Troubleshooting - Keurig B60 Use And Care Manual

Storage

Empty the Water Reservoir before storing and
take care to ensure that you store your
Brewer in a safe and frost free environment.
Please be sure to store your Brewer in its
upright position to avoid water leakage from
the inner tank. If you store the Brewer in a
cold environment, you run the risk of water
freezing inside the Brewer and causing dam-
age. When you prepare to use it after storage,
we recommend rinsing the Water Reservoir
with fresh water and running three cleansing
brews without a K-Cup.
If you plan to move your Brewer to a different
location, turn the Brewer off, unplug it and
empty the Water Reservoir. If your Brewer has
been in an environment below freezing, please
be sure to let it warm to room temperature for
2 hours before using.
14
SECTION 4

TROUBLESHOOTING

SITUATION SOLUTION
• Plug Brewer into an independent outlet.
Brewer Does Not
Have Power • Check to be sure that it is plugged in securely.
• Plug into a different outlet.
• Reset circuit breaker if necessary.
• Make sure that the Power Button has been turned on and is
illuminated.
Brewer will not brew
• The Brewer must be primed for use by filling the internal hot water
when used for the tank before the first brew. 'PRIME' will be displayed on the LCD
first time Control Center (refer to page 6).
• If Brewer is cold/frozen, wait for two hours for it to reach room
temperature.
Brewer will not brew • After placing the K-Cup
the Handle is pushed down securely and the LCD Control Center
reads 'READY TO BREW' with the three cup sizes buttons blinking,
then press the Cup, Mug or Travel Mug Button.
• If the LCD Control Center indicates 'ADD WATER', add water to the
Water Reservoir or make sure the Water Reservoir is seated properly
in its base.
• If the LCD Control Center indicates 'ADD WATER' even after refilling,
contact Customer Service at 1-866-901-BREW (2739).
• The Exit Needle may be clogged. (refer to page 11).
Brewing a partial cup
• Clean K-Cup Holder if necessary and rinse under faucet. (refer to page 11).
• The Water Reservoir may have been removed during brewing. Replace
the Water Reservoir and perform a cleansing brew without a K-Cup.
• If the LCD Control Center indicates 'DE-SCALE', descale the Brewer
(refer to page 11).
• If you have repeated the descale procedure on your Brewer two times
and the message is still displayed, contact Customer Service at
1-866-901-BREW (2739).
• The time will not be displayed on the LCD unless you have set it.
The time is not
To set the clock, follow the procedure on Page 9.
displayed on the
LCD Message Center
• If power is interrupted to the Brewer, you will need to set the clock
again using the procedure on page 9.
My brewer shuts off or
• Check to make sure that the Auto Off Timer and/or On/Off Time
turns on automatically features have not been set. To do this, press the black button below
'MENU' and scroll through the programming options. 'OFF' should
be displayed for Auto Off Timer and On/Off. If 'OFF' is not displayed,
follow directions on pages 9-10 to reset.
If any problems persist, contact Customer Service at 1-866-901-BREW (2739).
® portion pack in the K-Cup Holder, make sure
15