Miele SmartLine Operating And Installation Instructions page 33

Installing several
SmartLine elements
The gaps between the individual
SmartLine elements are sealed with a
silicone sealant that is heat-resistant to
at least 160 °C. With flush-fit
installation, the gap between the
SmartLine element(s) and the worktop
must also be sealed with a silicone
sealant that is heat-resistant to at least
160 °C.
After installation, the SmartLine
elements must be easily accessible
from below, so that the bottom half of
the casing can be removed for
maintenance. If the SmartLine elements
are not accessible from below, the
sealant must be removed so that they
can be removed.
Worktop depth
The downdraft extractor can be
installed with the connector for the air
duct on either the right or the left-hand
side.
Minimum worktop depth for
- Right connector 600 mm
- Left connector 665 mm
Installation
33