Table of Contents
Advertisement
2.
Press "Descaling".
The duration cannot be changed.
3.
Press
.
a A message stating that you should carry out the ne-
cessary preparatory work for descaling appears on
the display.
4.
Confirm the message.
a The descaling programme starts and the duration
counts down.
a Once the first part of the descaling programme has
finished, a signal sounds. The appliance prompts
you to carry out 2 rinse cycles.
5.
To rinse the appliance, for each rinse cycle:
21 Drying
To prevent residual moisture , dry the cooking compart-
ment following operation with steam.
ATTENTION!
If there is water on the cooking compartment floor
when operating the appliance at temperatures above
120 °C, this will damage the enamel.
▶
Do not use the appliance if there is water on the
cooking compartment floor.
▶
Wipe away any water on the cooking compartment
floor before operation.
21.1 Drying the cooking compartment
You can dry the cooking compartment by hand or use
the "Drying" function.
1.
Allow the appliance to cool down.
2.
Remove dirt from the cooking compartment.
3.
Wipe away the water in the cooking compartment.
4.
Dry the cooking compartment.
To dry the cooking compartment, leave the appli-
‒
ance door open for 1 hour.
22 Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
Note: Wipe the condensate trough without pressure.
22.1 Detaching the appliance door
WARNING ‒ Risk of injury!
Components inside the appliance door may have sharp
edges.
▶
Wear protective gloves.
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
▶
Keep your hands away from the hinges.
1.
Open the appliance door fully.
Open the control panel and remove the water
‒
tank.
Thoroughly rinse the water tank and fill it with
‒
fresh water.
Slide in the water tank and close the control
‒
panel.
Press
to start the rinse cycle.
‒
a A signal tone sounds when each rinse cycle has
ended.
6.
Once the second rinse cycle is complete:
Empty and dry the water tank.
‒
→ "Emptying the water tank", Page 19
Press
to switch the appliance off.
‒
To use the "Drying" function, set "Drying".
‒
→ "Setting the drying process", Page 29
Setting the drying process
Requirement: → "Drying the cooking compartment",
Page 29
1.
Press "Cleaning".
2.
Press "Drying".
The duration cannot be changed.
3.
Press
.
a A notification stating that you should carry out the
necessary preparatory work for the drying appears
on the display.
4.
Confirm the notification.
a The drying process starts and the duration counts
down.
a Once the drying has ended, a signal tone sounds. A
notification appears on the display confirming that
the operation has finished.
5.
Press
to switch the appliance off.
6.
To dry the cooking compartment completely, leave
the appliance door open for 1 to 2 minutes.
Drying en
29
Advertisement
Table of Contents
