Table of Contents
Advertisement
en Drying function
22.2 Setting the rinsing programme
Requirement: → "Preparing for rinsing", Page 31
1.
Press "Cleaning".
Press "Rinsing".
2.
The duration cannot be changed.
Press "Start".
3.
a A message stating that you should carry out the ne-
cessary preparatory work for rinsing appears on the
display.
Confirm the message.
4.
a Rinsing starts and the duration counts down.
a Once rinsing has ended, a signal tone sounds. A
message appears on the display confirming that the
operation has finished.
Press
to switch the appliance off.
5.
Drying function
23 Drying function
To prevent residual moisture , dry the cooking compart-
ment following operation with steam.
ATTENTION!
If there is water on the cooking compartment floor
when operating the appliance at temperatures above
120 °C, this will damage the enamel.
Do not use the appliance if there is water on the
▶
cooking compartment floor.
Wipe away any water on the cooking compartment
▶
floor before operation.
23.1 Drying the cooking compartment
You can dry the cooking compartment by hand or use
the "Drying function" function.
Allow the appliance to cool down.
1.
2.
Remove dirt from the cooking compartment.
Wipe away the water in the cooking compartment.
3.
Dry the cooking compartment.
4.
To dry the cooking compartment, leave the appli-
‒
ance door open for 1 hour.
Appliance door
24 Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
Note: Wipe the condensate trough without pressure.
24.1 Detaching the appliance door
WARNING ‒ Risk of injury!
Components inside the appliance door may have sharp
edges.
Wear protective gloves.
▶
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
Keep your hands away from the hinges.
▶
Open the appliance door fully.
1.
32
→ "Preparing the appliance for operation after rins-
6.
ing", Page 32.
22.3 Preparing the appliance for operation
after rinsing
Remove the connecting hose in the cooking com-
1.
partment from the socket.
Remove the container, with the connecting hose,
2.
from the cooking compartment, then empty and
clean it.
Wipe any liquid which has escaped from the cook-
3.
ing compartment floor, then wipe with clean water
and dry with a soft cloth.
Attach the shelf supports as required.
4.
→ "Rails", Page 36
To use the "Drying function" function, set "Drying
‒
function".
→ "Setting the drying process", Page 32
Setting the drying process
Requirement: → "Drying the cooking compartment",
Page 32
Press "Cleaning".
1.
Press "Drying function".
2.
The duration cannot be changed.
Press "Start".
3.
a A notification stating that you should carry out the
necessary preparatory work for the drying appears
on the display.
Confirm the notification.
4.
a The drying process starts and the duration counts
down.
a Once the drying has ended, a signal tone sounds. A
notification appears on the display confirming that
the operation has finished.
Press
to switch the appliance off.
5.
To dry the cooking compartment completely, leave
6.
the appliance door open for 1 to 2 minutes.
Advertisement
Table of Contents
