NETGEAR WAX630E User Manual page 55

Insight Managed WiFi 6E AXE7800 Tri-band Multi-Gig Access Point Model WAX630E
the 6 GHz band as the preferred band for its backhaul connection. Using the Insight
Cloud Portal, you can change the backhaul settings.
To use the NETGEAR Insight app to connect the extender access point to a root
access point in an existing WiFi network:
1. Make sure that the mesh mode for the Insight network location is set to Auto.
For more information, visit kb.netgear.com/000064932.
You cannot use the Insight app to change the mesh mode for the Insight network
location. You must use the Cloud Portal. For all other steps in this procedure, you
can use the Insight app.
2. Make sure that the mesh mode for the root access point is set to Auto.
For more information, visit kb.netgear.com/000064929.
3. Make sure that extender access point is in factory default state.
If you used the extender access point in your network before, reset the access point
to factory default settings.
4. For a reliable WiFi connection, place the extender access point less than 25 feet
(7.5 m), in a line of sight with minimal obstacles from the closest root access point.
5. Connect the extender access point to a power source.
The Power/Cloud LED of the extender access point lights amber and then lights
green.
Note: To prevent a network loop, connect the extender access point to a PoE++
switch that is not connected to the same network as the root access point or to the
Internet. You can also use an optional power adapter.
6. Connect your mobile device to the existing WiFi network that includes one or more
root access points.
7. Launch the Insight app and sign in to your account.
8. Select the Insight network location with the root access point.
In most situations, the Insight app detects the extender access point automatically.
This process might take a few minutes.
Install the Access Point in an
Insight Instant Mesh WiFi
Network
55 User Manual