Table of Contents
Advertisement
•
If the interior sensors detect
movement within the vehicle.
•
On vehicles with a battery
back-up sounder, if someone
disconnects the vehicle battery or
the battery back-up sounder itself.
•
If the tilt sensors detect a change
in the inclination of the vehicle.
If the alarm is triggered, the alarm
horn will sound for 30 seconds and
the hazard warning flasher will flash
for five minutes.
Any further attempts to perform one
of the above will trigger the alarm
again.
Full and reduced guard
Full guard
Full guard is the standard setting.
In full guard, the interior and tilt
sensors are activated when you arm
the alarm.
Note: This may result in false alarms
if animals or moving objects are
inside the vehicle or, on vehicles with
tilt sensors, when travelling on a ferry.
Reduced guard
In reduced guard, the interior and tilt
sensors are deactivated when you
arm the alarm.
Note: You can set the alarm to
reduced guard for the current ignition
cycle only. The next time you switch
on the ignition, the alarm will be reset
to full guard.
Alarm
Ask on Exit
You can set the information display
to ask you each time which level of
guard you wish to set.
If you select Ask on Exit, the
message Reduced guard?
appears in the instrument cluster
display each time you switch the
ignition off.
If you wish to arm the alarm with
reduced guard, press the OK button
when this message appears.
If you wish to arm the alarm with full
guard, leave the vehicle without
pressing the OK button.
Selecting full or reduced guard
Note: Selecting Reduced does not
set the alarm permanently to
reduced guard. It sets it to reduced
guard only for the current ignition
cycle. If you regularly set the alarm to
reduced guard, select Ask on Exit.
E70499
46
Advertisement
Table of Contents
