Change; Default Parameters - Jacobsen ZB Series Safety, Operation And Maintenance Manual

5 CONTROLS
5.2.Z.48 PIN CHANGE _____________________________________________________
Select the PIN change  and accept
5.2.Z.49 NEW PIN ________________________________________________________
Press the button up and down
Select . To accept.
5.2.Z.50 INCLINOMETER __________________________________________________
Select to shows TST status, Enabled or Disabled.
Press the button up and down
between Enabled or Disabled Select
5.2.Z.51 SET DEFAULT PARAMETERS
Select the Set Default Parameters  and accept
Select . To accept.
Press the button up and down
between YES or NO Select
en-40
.
to move forward the numbers.
to move
. To accept.
.
to move
. To accept.
P i n M e n u
C r u i s e C o n t r o l
C r o s s C u t
Ve h i c l e S p e e d
Ch a n g e PIN
I n c l i n o m e t e r
Se t D e fa u lt Pa r a me te r s
Dr ive Mo d e s
SET Default Param Values
Press Push Buttons To SET
D e f a u l t P a r a m e t e r s Va l u e s
P i n M e n u
C r u i s e C o n t r o l
C r o s s C u t
Ve h i c l e S p e e d
C h a n g e PI N
C h a n g e P I N
0
N e w P I N
T ST Setting
TST Sta tu s Not Fi tted
P i n M e n u
C r u i s e C o n t r o l
C r o s s C u t
Ve h i c l e S p e e d
Change PIN
I n c l i n o m e t e r
Set Default Parameters
Drive Modes